Well Completion and Workover

BACKGROUND:

Well Completion and Workover are two activities in oil and gas industry, regardless it is oil or gas wells. Initial completion is the activities to allow production fluid to flow into the well bore and eventually flow to surface facilities. Workover carried out when the oil or gas production start declining overtime. Hence as it is said, Workover done over and over. Well completion normally done once in a life time of an oil/gas well. However, workover done almost regularly when Production Engineer see the posibility to improve production rate.

Oil and gas activities involve high capital investment and high risk as the operation deals with flame able fluids, high pressure and high temperature. Therefore, whoever involve in the activities must be knowledgeable, qualified ones and better to have enough experience. However, in fact not all people involved have enough prerequisite to do the job. As such, supplementary training should probably be required to ensure the activities carried in safe, technically sound and environment friendly.

OBJECTIVES:

After attending this training participants expected to:

• Understand correct prosedur and technique of well completion dan workover
• Recognize and familiar with equipment related to workover and well completion
• Undestand technique and function of well stimulation
• Analysis well problem and give the right solutions
• Improve well flow performance
• Design workover and well completion
• Analisa completion and workover results

TRAINING CONTENT:

1. Basics of Production Techniques: Reservoir flow energy, Oil well production testing, Gas well production testing
2. Well Completion Practices: Types of well completion, Interval selection and productivity considerations
3. Downhole Production Equipment: Tubular products, Packers, Circulating devices, Nipples, Blast joint and flow coupling, Telescopic swivel joints, Subsurface Safety Valves, Artificial lift equipment, Wellhead Assemblies
4.  Perforating: Shaped charges, Industry testing procedures, Gun categories, Specialized equipment and operation, Casing deformation/damage, Perforation productivity considerations, Field completion considerations, Wellhead pressure control, Depth control technique
5. Production Problems
6.  Sand Control: Basic technology, Control methods, Program engineering
7. Types of workovers: Full-bore, Thru- tubing
8.  Workover equipment: Rigs, Hydraulic (Snubbing) Units, Coiled tubing
9.  Workover fluids selection
10.  Hydraulic fracturing
11.  Acidizing
12.  Acid-Hydraulic Fracturing
13.  Corrosion, Scale, and Paraffin Removal
14.  Changing of Production Zones
15.  Leak Detection and Isolation
16.  Economic Analysis and Decision

WHO SHOULD ATTEND:

• Drilling Team: Engineer, Superintendent, Supervisor
• Well Services team: Rig Manager, Service Company Drilling, Rig Supervisor
• Petroleum Engineering Team: Workover engineer,  Production Engineer, Production superintendent, Production Supervisor, Senior Operator
• HSE Supervisor, and Maintenance Supervisor.

TRAINER:

Prof. Herianto, Ir., M.Sc., Ph.D.

Anda mungkin suka:

1. Oil & Gas Surface Facilities 
2. Well Completion & Workover

Related posts:

Oil & Gas Production System: From Well Completion to Export Formation Damage, Well Stimulation Introduction to Offshore and Subsea Drilling Sand Control Management